I have over time acquired two crack free center sections for the 17x10, et17 version of this wheel. I would like to buy barrels and lips needed to assemble them to the original specs.
Based on my measurements/calculations (which could be a little off) I need 6.75" barrels and 3.25" lips to arrive at an et of 17, but I've only been able to find the OZ barrels/lips in half inch increments.
So do I need 6.5" barrels and 3.5" lips, or 7" barrels and 3" lips? I know atleast a few of you have split/re-assembled some sets of these...
Thanks in advance!